The Ultimate DIY Wet Wipes Hanging Holder
If you love practical, scrap-busting sewing projects that actually get used every single day, this one is for you. We are making a stylish, reusable wet wipes pouch complete with a handle that snaps right onto your stroller or car seat. Not only does it look so much better than the crinkly store packaging, but it’s also a fantastic beginner-friendly project. Let’s dive into this easy sew!
The finished measurements of this SPROUT BABY WIPES HOLDER are approximately
20cm(8") W × 12cm(4¾") H × 8cm(3¼") D.
20cm(8") W × 12cm(4¾") H × 8cm(3¼") D.
You may watch the full video tutorial on my Youtube channel.
Share this video with a lot of people who need it.
Let's get started!!
◆ Main panel
② 29.5cm × 21cm (11¾" × 8¼") Exterior
② 29.5cm × 21cm (11¾" × 8¼") Lining
② 29.5cm × 21cm (11¾" × 8¼") Fusible fleece
◆ Others
① Zipper_seam allowance excluded 20cm(8")
① 1.5cm(5/8") Wide Webbing Strap 23cm(9⅛")
① Plastic Snap Buttons
Place the front Lining and Exterior right sides together and stitch around the marked wipe lid opening.
Cut out the center of the opening, clip the curved seam allowance, and push the Lining through the opening. Press the wipe lid opening flat and topstitch neatly around the edge.
Attach the zipper to the top edge of the front Exterior panel, aligning the center marks and positioning the zipper slider on the left. Attach the front Lining to the zipper, keeping the lower portion of the panel out of the way while stitching.
Attach the back Exterior and Lining to the zipper and topstitch along the zipper.
Place the two Exterior panels right sides together and stitch the side and bottom seams. Stitch the side and bottom seams of the Lining, leaving an opening at the bottom for turning.
Box the bottom corners of both the Exterior and Lining by aligning the side and bottom seams and stitching across the corners.
Box the corners near both ends of the zipper, carefully aligning the side seams with the zipper teeth.
Turn the project right side out through the opening in the Lining. Fold the raw edges of the turning opening inward and stitch close to the edge to close it. Attach the snap socket to the short strap and the snap cap to the long strap, with both facing outward. Fasten the snaps together to create the convenient hanging handle for the wipes holder.
All done! We hope you enjoy creating your own wonderful piece.
And be sure to check out the
[Sewingtimes YouTube channel] for more creative projects.
Sew This Clever 3-in-1 Zipper Everyday Tote!And be sure to check out the
[Sewingtimes YouTube channel] for more creative projects.
