How to make a Drawstring Cell Phone Crossbody
Make a lightweight canvas crossbody that opens with a simple pull—perfect for busy hands and quick errands.
There’s a front pocket for your phone, a comfy handle for grab-and-go, and a tidy, unified look thanks to matching canvas.
Even if you’re a beginner, the steps are calm and clear. Brew a tea, gather your fabric, and let’s sew something you’ll actually use every day.
The finished measurements of this bag are approximately
15㎝(6″) W × 20㎝(8″) H × 3㎝(1¼″) D.
You may watch the full video tutorial on my Youtube channel.
Share this video with a lot of people who need it.
Let's get started!!
◆ Main Panel
② 20㎝ × 20.5㎝ (8″ × 8⅛″) Outer layer
① 20㎝ × 45㎝ (8″ × 17¾″) Lining
◆ Bottom panel
① 20㎝ × 8㎝ (8″ × 3¼″) Outer layer
◆ Front pocket
① 12㎝ × 20.5㎝ (4¾″ × 8⅛″) Outer layer
◆ String sleeve
② 18㎝ × 7㎝ (7⅛″ × 2¾″) Outer layer
◆ Handle
② 62㎝ × 5㎝ (24½″ × 2″) Outer layer
◆ Strap
① 120㎝ × 5㎝ (47½″ × 2″) Outer layer
◆ Strap holder
② 5㎝ × 4㎝ (2″ × 1⅝″) Outer layer
◆ Others
① Drawstring Cord 115cm (45½″)
Cut the Bottom panel and Main panel lining into the shape of the pattern.
Fold the pocket panel twice with the right side facing out and sew the top.
Place the pocket on the right side of the outer layer and sew.
Place the handles 11㎝(4⅜″) apart on the main panel.
Sew only up to 18㎝(7⅛″) from the bottom.
Then connect the main panel and the bottom panel.
Fold both sides of the string sleeve fabric inward, then fold it in half lengthwise.
Place the string sleeve on the right side of the lining and sew.
Place the right sides together of the outer and lining and sew the top and bottom.
Flip the layers so the outer bag pieces are right sides together, and the lining pieces are right sides together.
Sew with an allowance of about 1㎝(3/8″), leaving an opening.
Turn it right side out by pulling the fabric through the opening.
And sew up this opening.
Arrange the lining inside and stitch the middle of the string sleeve.
Start inserting the string through one end of the casing, using a safety pin.
Continue inserting the string into the casing on the other side.
Next, take the other string and start inserting it through the casing from the opposite side. Continue as before.
Tie the ends of the string in a knot.
Thread the shoulder strap through the loop and tie a knot.
You are finished!!!
Thanks for reading!
More creative content is just a click away :)
