Create Your Perfect Wallet:
DIY Fabric Tutorial for Everyday Use!
Are you ready to add a handmade touch to your everyday accessories?
Our DIY fabric wallet tutorial is just what you need! In this step-by-step guide, we'll walk you through the process of creating a small wallet with a zipper pocket on the back.
With six credit card slots and space for bills, this wallet is perfect for keeping your essentials organized on the go.
Whether you're a beginner or an experienced crafter, this project is sure to inspire you to get creative.
The finished measurements of this wallet are
approximately 12.5㎝(5″) W × 9.5㎝(3¾″) H .
You may watch the full video tutorial on my Youtube channel.
Share this video with a lot of people who need it.
Let's get started!!
◎ Main Panel
① 12.5㎝ × 9.5㎝ (5″ × 3¾″) Outer layer
① 12.5㎝ × 19㎝ (5″ × 7½″) Outer layer
① 12.5㎝ × 27.5㎝ (5″ × 10⅞″) Lining
① 12.5㎝ × 8.5㎝ (5″ × 3⅜″) Fusible fleece
① 12.5㎝ × 18㎝ (5″ × 7⅛″) Fusible fleece
◎ Zipper Pocket
① 12.5㎝ × 18㎝ (5″ × 7⅛″) Lining
① 10㎝ (4″) Zipper
◎ Card Holder
② 35㎝ × 11㎝ (13¾″ × 4⅜″) Outer layer
① 20㎝ × 11㎝ (8″ × 4⅜″) Outer layer
① 20㎝ × 11㎝ (8″ × 4⅜″) Lining
① 20㎝ × 11㎝ (8″ × 4⅜″) Mid-weight woven fusible interfacing
◎ Others
① 4㎝(1⅝″) wide bias tape 120㎝(47½″)
① Set of Snap Buttons
With assembled lining of the zipper pocket right side up, center zipper right side facing up along top edge.
Place the outer layer of the main panel, right side down on top. Pin in place.
Using your zipper foot, sew along top edge using a 1㎝(3/8″) seam allowance.
Open out, press pieces away from the zipper.
Fold the lining and place it on the other side of the zipper.
Sew together with the other outer layer of the main panel.
Open out, press pieces away from and top stitch on both 0.3cm away from the zipper.
Place the wrong sides together of the outer and lining and sew all the edges.
Please refer to the video and fold the card holder.
Place card holders on both sides of the outer layer.
Sew together all the edges.
Attach the bias tape on top and right sides of the card holder.
Place the card holder on the inside of the main panel and sew.
Attach the bias tape on the all the edges.
